WHAT YOU DID TO YOUR TRUCK TODAY!

[Derv23]

.
Wishing him/her a speech recovery.
Mines is still off the road

[JEOH]

Step by step



tyres was the last on their list. Tomorrow the next try.

With passend mot I will swap the tyres with those of Marions Frontera. The wife deserves only the best!

[frontster]

Fitted the new crankshaft pulley today, couldn't find the torque settings anywhere so used some thread lock and tightened to 100Nm. It's good to get back on the road again to fly the Frontera flag as there aren't many over here.

[fudge]

i got the duck back together at last and started her last night for the first time in over a year
think i may have more work to do...

new cam shaft here i come

[snapper]

[frontster]

Mot due at the end of the month, so fitted new windscreen wipers and inner and outer cv boots on both sides.

[ghosthunter]

Another year...another Mot.
Passed first time.

More than can be said for bag o' sh*te no.1
Now parts doner for b'o' sh*te no.2.
Got a good x22se engine if anyone's interested.

[Fronterror]

Changed lower ball joints and wheel bearings both sides, replaced dash lights and finally changed the rear shocks

[snapper]

Finally got of me ***** to get on with sorting Truck out for a MOT next week....

That 'small' hole in the N/S sill under the rear door turned out to be close to 550mm long and ran from the wheel arch, ended up cutting everything away from the bottom sill seam to about 10mm down from the top. Then spent about an hour cutting, bending and fettling a new sill section to match the shape out of a piece of 1mm sheet steel from BnQ. That's now welded in place and awaits a few daps of filler and some paint in the morning.

Also found another hole, this time next to the front body mount. Also patched and awaiting paint.

Final spot of welding to do can wait for the morning, this time it's the O/S rear mount for the axle bump stop, spotted it earlier when doing the sill repair on the other side. It's not fully gone (yet) but I will sort it before MOT boy gets a chance to make comment.

Apart from that, a wire brush across all of the brake unions and rip out the old now redundant fuel lines (ran new ones in last year, just not removed the old ones yet), a quick service and it should be okay.....

I might, and it is might even give it a wash before taking it down!

[Fronterror]

MOT passed for another year, advisories for corrosion to nearside chassis outrigger and rear bumpstops fully corroded

[enginseer]

Fixed the cooling fans and made a new oil dipstick... Thanks to Fronterror I'm able to read the oil level also, new radiator... VM ready for the summer!