WHAT YOU DID TO YOUR TRUCK TODAY!

[4x4 bobby]

Managed to put the farm jack under the back door and lift it, at least i can open the feckin thing now without climbing into the boot with a screw driver!!!

[yaki]

Primered the front wings, hopefully giving them a quick rub down tomorrow might and then squirt some colour on them

Refitted the roof console now that the wiring is finished

[Hawkmoon]

.. new brakes !

and ... the original airbox ! Hurra!

[yaki]

Quick wet flat of the front wings and top coat is going on, not looking too fab at the mo as I'm using spray cans but its better than a 2 tone shorty and no doubt will soon get them nice n scratched

[yaki]

Bought more spray paint as yesterdays job is looking a bit patchy

[snapper]

Truck:

Fixed this


Not the smartest of patches, but hey it works....


Just needs some paint now.

[snapper]

Truck

Also, moved the winch bumper project on a bit. Now done the little bits of bumper leading to the wheel arch trim and welded in some plate to try and protect the body section below the headlight mounting that seemed a bit 'exposed'

Side bumper


Protective plate


Nearly finished, just a top bracing bar/spotlight mounting bar to make and fit and drill out the shackle mounts to 20mm

[gregster]

[4x4 bobby]

Blew the feckin turbo!!!!!!!!!!!!!!!!!!!

[4x4 bobby]

Fitted another turbo and put on nut's & bolts that someone else bloody left off!!!!

[dave1966]

I did this yesterday.

Wired up my amber LED side marker lights on the side step there is a total of 60 amber LED's on each side step.

How they look in the daylight:-


How they look at night:-


How they look in the daylight:-


How they look at night:-

[snapper]

Used it to drag the caravan down to Stoke Gabriel, Devon for weeks holiday. Tis well hot down here, off to find some more beaches in a bit. And no, Im not leaving it on the beach

[Hawkmoon]

[hipo1024]

Day off today so I've finally finished doing the wheels bearings lol only taken a week pmsl. Next up is crack on and finish off the bumper

[snapper]

Mmm...

Was just about to go get the tools n bits from the shed and do a cam belt change on Truck followed by the front wheel bearings... I say was as the sky has just emptied a bucket of water over the town and it's still coming down!

[snapper]

Took me phone (N8) to bits instead and replaced the main speaker, lot's n lots of very small bits lol... Amazingly I even got it back together again and it works


Now for the truck as it's stopped raining

[MARTIN FROM LLAN]

Bled up the complete brake system, had no brakes for twelve months. Did handbrake on monday night, this still needs adjusting. Balljoints next and check underside for rust, then mot first in 2 yrs, fingures will defo be crossed.

[4x4 bobby]

Good luck fella, i know how tence it can be!!!!

[mudman1988]

I gave the bank account a battering ordering shiny stuff for my truck to stop my springs falling out got a bit of bar to clamp my springs at the top a set of land rover dislocation cones witch will probably need a bit of fettling and a extended rear brake hose oh and a new tow bar I'm going to be busy before the weekend'er

[fudge]

and this morning i take the duck out and then come back on a low loader

... screwed my front wheel bearing