WHAT YOU DID TO YOUR TRUCK TODAY!

[fudge]

well yhe mud will be comming off soon, and what about engine oil, there seams to be loads of that around the area

[RatCav]

What yours or mine. Still have to source my leak ... wondering more and more if its my rear crank seal now.

[fogman]

you boys should be thinking about getting yourselfs a good old trusty 2.2 petrol b & you wont have all those problems

seriously if your having a spanner party in the next few weeks guys give us a shout & ill bring my lunchbox

[fudge]

well fogman come along to the 4x4 show.

you can have a look at my clean fronty. just spent 30 mins cleaning it

[hipo1024]

don't say that! . the front one cost f-ing £15.24 what a rip off! looks exactly the same as a front bearing seal that costs about £2. I hope the rear one is fine! j think my rear oil leak is the vac pump coz its high up. and tbh its not a bad one so it can wait

I havnt looked into that show yet, what's happening there, is it a go and look at things show or a go and watch me get stuck show? .

[RatCav]

Have a read Dan

viewtopic.php?f=49&t=38261

[drinksoptional]

Sorted new bulbs for lwb got mot retest at 4pm

[fogman]

[drinksoptional]

got the mot cert one down one more to go

[mickh]

If you only drive those 2.2 petrols round town now and then they would be pretty reliable. I have a caravan axle you could put on that box Fogman would make a good trailer.

[pot bellied pixie]

Got It through the MOT , just the clutch and crank oil seal to go

[BoxCleva]

Confirmed clutch is foobarr and have no time to fix. Grrrrr

[drinksoptional]

no luck you going to fix it

[BoxCleva]

I'll probably do what I always do, wait until it's almost undriveable then fix it.

[pot bellied pixie]

[hipo1024]

whats wrong with yours box? - oh and you know when I said "of all the things I thought I would of broken....." lol well I cleaned the underneath of the truck today....and the front of the tank gaurd is a good inch higher that its ment to be (And I didnt think I hit it all that hard tbh, just dragged it fairly slowly over most things from what I remember, it was the front that did all the hitting and thats fine ) and also some what worryingly the crossmember that the torsion bars connect to has a load of small dents at the ends near the welds....I just hope it havnt bent the chassis! Other than that it seems to be business as usewell!

[fudge]

well dan if your worryed abouit the welding
pop along over the weekend and i will cast my eye over it. and we can then see if anything is wrong

[jason]

[fudge]

just spotted these on ebay, listed for a lwb


but after asking a question, i have found out these are adjustable, and are made for an A fronty, so may be having a go for mine

[fudge]

yea good point, it would be for once ive done a body lift, so they can be at the same hight as he chassey