WHAT YOU DID TO YOUR TRUCK TODAY!

[andysd1]

yes mate, a small one, lol









on both sides,

[Drift]

Very nice

[BoxCleva]

What to power ?

[Krusher]

Hope your not planning on doing much wading Andy, that gonna get erm....ruined

[andysd1]

they are exterior ones,

[andysd1]

[Krusher]

I'll shut up then mate..

[andysd1]

the out side plug is a snug fit, and i silicone the back as well, just to make sure

[jellybaby]

sure bobsters done the same

[4x4 bobby]

I pinched the idea from Trugg's so dont worry about it mate!!
Dont forget to have them switched though Andy.

[andysd1]

[Krusher]

I would say, I case some scrote decides to jam something in it and blow your fuses.....

[andysd1]

got them on an independent 30amp fuse

[wokkaben]

Lowered the For Sale price £700 for FOG members

[BoxCleva]

Decided to fix my door that fell off

Now I can't weld to save my life, so I decided to enlarge the hole the hinge ripped out and put some flat bar behind it and bolt through that.



Door being held up on an axle stand



Needed to whip the front wing off to get clear access






All sorted with new studs. Nice to have a door that opens with out falling off

[Drift]

Proper job

[andysd1]

nice

[BoxCleva]

Have tools - can bodge

[James Bass]

Si.

[snapper]

Well.... for a few days now the old truck has been mildly challenged by hills, slopes and at times even the more severe speed bumps, on investigation I found a non-rotating turbo (it wasent seized cos it would 'wiggle' about 0.25mm in each direction). Checked the oil and coolant supplies yesterday which were okay and began to seperate it from the exhaust adaptor for a looksee last night when I ran out of light and ended up putting it all back together ready for work today.

Drove all the way down to Erskin Bks, Wilton at stupid o'clock this morning and the truck fair flew up the hills, seems the Turbo has decided to get a grip and start working again Can only think it must have been me whacking it last night with a 1/2lb ball pein hammer to loosen the thing away from the adaptor that shook whatever it was jamming it up free, so as results go that was a good un.....


A far better result than me, later on putting the front wheel through a cast iron manhole cover good job it was in 4 wheel drive at the time. Just climbed right on out the hole

Just hope the turbo keeps going for a few more months now while I try and sort a shiny new one out.