WHAT YOU DID TO YOUR TRUCK TODAY!

[dave1966]

Changed the anti roll bar drop links today.

These are the old drop links,which I had to cut off with a grinder:-



New anti roll bar drop link on the drivers side and no-more strange squeaking noise:-



New anti roll bar drop link on passenger side:-



Just got to clean off the power steering fluid on passenger side.

[andytats]

Spent about 4 hours under the car today wire bushing the chassis then waxoiling all of the underneath on the 2.8

[chrispynuts]

I thougth i would repair the rust spots on my bonnet this weekend , rubbed the whole lot down fixed the rust spots all looked good then decided to paint the whole bonnet ... there isnt enough swear words in the world to describe the mess that two pack paint can cause if you put it on incorrectly ans have to rub it all down on a Sunday and discover you havent got enough top coat S*&T.

[gregster]

What problem are you having with the paint?

[Drift]

Oi

[4x4 bobby]

[gregster]

Damn...sorry Ste, done it again.

[Drift]

[2much]

new straight through exhaust fitted

[fudge]

started work on my rear winch tray....
shold be done in a week or so. then just need a winch for it

[gregster]

Started ripping a 2.8lwb apart...shame but it will keep many more alive

[Drift]

Very noble

Mine is pretty much the same position it was from the meet all be it with a dead battery, could be three more weeks before I can drive it or work on it

[gregster]

[andytats]

Haven't worked on the truck today but I've spent nearly all day looking for tyres
One set for the 2.8 lwb
One set for the 2l swb
One set for the trailer

[gregster]

But did you find any????

[andytats]

trailer --- £156 for a set of four 165 80 r13c 8 ply
SWB ---- silverstone extreme tyres 33.10.5.15 set of 6 ( I haven't bid on them yet )
Whilst I was on eBay I find some toys too. Plasma cutter + engine hoist
And bid on another frontera

[snapper]

O-no... Took the leaky rear diff cover off and fitted one that I had welded up earlier. Now to fix the one that came off. Oh and re-filled the diff with fresh oil too...

[chrispynuts]

[robbie]

Fitted new top and bottom ball joints to both o/s and n/s also new n/s/f shocker will fit the o/s/f tomorrow. time for a birthday . lol

[storesafe]

Spent 3 hours stripping, checking, re-soldering board on the damn speedo cluster after it started with the dreaded fault on Wednesday last week.
Still dunt work n can't be arsed to go over it again (did try it a couple of times) off to some electronic guru tomorrow.