Frontera Technical Support

Looking to get 4 alloys with tyres from Colwyn Bay.

They're on ebay at the moment: http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... K:MEWAX:IT

If I can get some way of getting them up here I'll start my bidding Happy to contribute to fuel and what not

Hi bud, make sure you know that they are off a LWB as the offset is different.
Good luck.

!!!

Where would I be without you keeping me straight?

Thanks Keith!

They will be ok on long or short TDS as they were the same offset on the A series coil sprung model

If you win them, while transport is being sorted out, I can certainly collect them for you

If hte timing is right and Im down there I can stick them in my mums garage in Abergele.

if i can work my magic i might beable to get them
courierd up to me then we can sort something out
about getting them over to you im not that far from you
just ask Keith he knows me, and it wont cost a bean to
me to get them from Wales (work for a courier) just let
us know what you are doing.

rgds Ash.

Excellent. Thank you all so far!

Dam its good here aint it

Drift wrote:Dam its good here aint it

It sure is eh?
Who is this Ash guy? Never heard of him, have you?

Keith GET STUFFED.

ashbrear wrote:Keith GET STUFFED.

Hey up domino are you going to bid
for them wheels.

Not sure yet mate.

Will see if my current wheels are porous shortly. If so, I'll need to get another set pronto

domino wrote:Not sure yet mate.

Will see if my current wheels are porous shortly. If so, I'll need to get another set pronto

If they are porous mate...just pop the tyres of the rims and respray em inside, then refit the tyres.... that normally sorts em out...

Either that or stick 1/4 of a can of tyre weld in each tyre...drive it straight away though so it doesnt all solidify at the bottom!

Either that or stick 1/4 of a can of tyre weld in each tyre...drive it straight away though so it doesnt all solidify at the bottom!

Full can, did it on my old sport, worked a treat, let tyres down, spay in, pump tyres up go for 15 to 20 mile run immediately, job done and did me a lot of miles before the car was written off.

gregster wrote:

domino wrote:Not sure yet mate.

Will see if my current wheels are porous shortly. If so, I'll need to get another set pronto

If they are porous mate...just pop the tyres of the rims and respray em inside, then refit the tyres.... that normally sorts em out...

Either that or stick 1/4 of a can of tyre weld in each tyre...drive it straight away though so it doesnt all solidify at the bottom!

Respray them inside you say? What do you mean?

Hi All,

Thanks very much for the offers of help but it looks as though my wheels will be okay for the time being.

Cheers,

Mart