![Twisted Evil :twisted:](./images/smilies/icon_twisted.gif)
![Twisted Evil :twisted:](./images/smilies/icon_twisted.gif)
//
liffting points for a hi lift jack
6 posts
• Page 1 of 1
liffting points for a hi lift jacki was looking at a hi lift jack for my truck . so were do i put it to lift my fronty do i have to fit jacking points or will the metal bumpers be strong enough
![]() ![]() ![]()
Re: liffting points for a hi lift jackAlmost sure carl 'Red oktober' lifts his from his bumpers.
Re: liffting points for a hi lift jackIve seen Fronties up in the air off bumpers, but wouldnt myself. The rear chassis is easy to access and a good lift point could be put on either corner and even center if you dont have a tow bar.
Front and sides are a bit tricky as it must drop from Chassis before coming out. Fronty no.4, pimp mobile Treg 3.2 LWB lifted 2.5"
Fronty no.5 2.8 swb hd coils +2" 31"machos.
Re: liffting points for a hi lift jacklifting off the rear bumper with a "Hi-lift" ...been there done that
![]()
Re: liffting points for a hi lift jackLifted the front on the Bullbar
![]() ![]() No problems, just make sure the handbrake is on proper like ![]() Did try the back as Carl demonstrated on my breaker, make sure you chock the front wheels and the jack doesn't try and lift both rear wheels off at the same time ![]() ![]() Soon to be without a Frontera after 10 years of owning one
![]()
Re: liffting points for a hi lift jackThere was concrete blocks to stop it rolling forward
on my pic .....theres 5 holes left till the top of the jack ....and the rear wheel is only 2" clear of the ground ![]()
6 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: Facebook [Linkcheck] and 9 guests | ||